Work gloves for mechanical risks are marked with a hammer pictogram and a code under it, such as 4X43F. Each position is a separate test under EN 388. The decoder explains every digit and letter, so you can compare gloves from different suppliers and specify the level you need.
Reading the code
The first four digits are, in order: abrasion (1–4), coupe blade cut (1–5), tear (1–4) and puncture (1–4). Since the 2016 revision a fifth character, a letter from A to F, gives the result of the ISO 13997 cut test, and an optional P shows the glove passed the impact test for the knuckles and back of the hand. An X means the test was not done or doesn't apply, and 0 means tested but below level 1.
The coupe test uses a rotating blade that can go blunt on glass-fibre and steel-fibre yarns, so high-cut gloves often show X in the second position. For those, the ISO letter is the result to compare. When you specify gloves, ask for the cut letter: "EN 388, cut level C or higher" is clear; "cut level 5" is not.
Other glove standards to check
- EN ISO 374-1 for chemicals: Type A, B or C with the letter codes of the chemicals tested, and the breakthrough time.
- EN 407 for heat and flame, and EN 12477 for welding gloves.
- EN 511 for cold, used for freezer and cold-store gloves.
- EN 60903 for electrical insulating gloves, by voltage class.
- EN 455 for medical examination gloves.
Frequently asked questions
What does 4X43F mean on a glove?
Is cut level 5 the same as cut level F?
Which cut level do I need for handling sheet metal?
Does a high puncture level protect against needles?
Related PPE
- HZ-06Safety GlovesEN 388 mechanical risks
- IN-03Welding PPELeather welding gauntlets
- IN-02Construction PPESANS 1397 hard hats
- IN-06Medical PPENitrile, latex or vinyl gloves
More PPE tools
- TL-01PPE Budget CalculatorAnnual PPE cost per employee, per month and per new starter
- TL-02PPE Selector by HazardTick the hazards on the job and get the PPE list with standards
- TL-03Noise Exposure Calculator8-hour noise dose, allowed time and the ear protector SNR you need
- TL-04Respirator Protection Factor CalculatorRequired protection factor, mask class (FFP2, FFP3, full face) and filter colour
- TL-05Fall Clearance CalculatorFree fall, total fall distance and the clearance a lanyard or SRL needs
- TL-06PPE Size Chart and Size-Run BuilderBoot, glove, overall and vest sizes, plus a size run for your quote
- TL-08PPE Standards and Replacement GuideSANS and EN standards for each item, and when to replace it
